The Launch of New Quon is a Big Deal for UD Trucks in Australia
December 08,2017
Last week a range of Quon trucks were made by available to Australia's road transport media for the first drive in this country.
The diverse range, from a B-double to 6x2 rigids, demonstrates the flexibility of the line-up.
Back at the time of the Brisbane Truck Show, Nobuhiko Kishi, a Senior Vice President of UD Trucks Global said "the new generation Quon focuses on the five essential areas that drive smarter logistics: drivability, fuel efficiency, safety, productivity and uptime”.
These sentiments were echoed in the presentation that preceded the Brisbane test drive.
The trucks and trailers were parked up and ready to roll at the Volvo Group dealership in the Brisbane riverside industrial precinct of Pinkenba.
The flagship of the group was the 460hp Quon 6x4 prime mover hooked up to a B-double set, grossing 60 tonne.
Two prime movers rated at 420hp, one a 4x2, the other a 6x4, were pulling tri-axle trailers.
Two new CD models, long wheelbase 6x2 rigids pulled out under the power of the 390hp rated engines.
Two tipper variants, one a tipper and dog combo with the Quon 460hp big banger and the other a tipper and equipment trailer with the smaller 390hp rating.
The Quon was first released back in 2004 and Acting VP of Sales for UD Trucks in Australia Mark Strambli said while group technology has been quietly introduced since 2013, the truck has not had a major upgrade since its launch 13 years ago.
"The Quon was the first truck offered on the market with SCR in Australia from a Japanese manufacturer,” Mr Strambli tells Big Rigs.
The 2017 upgrade brings the advantage of the traditional longevity and strength of a Japanese truck with the global component approach of the international Volvo Group, and if the predicted mix is successful, this dual ancestry that could work well for UD Trucks both in Asia and in other markets such as Australia.
Transmissions, differentials, engines and electrical architecture are all group technology shared, with some interpretation, with other Volvo Group brands.
"We call this Tier Two and that's the latest technology available in the marketplace,” Mr Strambli said.
The new Quon trucks boast European safety packages, "adaptive cruise control that comes with driver alert. It has a radar sensing emergency braking system, lane departure and disk brakes”.
"This vehicle has a suite of safety features that has never been seen before in Japanese trucks,” Mr Strambli said.
I asked the UD boss if he thought these advances gave the Quon a marketplace advantage over other Japanese manufacturers.
"We think it does. We think other Japanese manufacturers are probably 18 months away, maybe even longer, in being able to match the technology,” he said.
The new Quon trucks are powered by the GH11 engine, an 11 litre straight six- cyclinder available in 390, 420 and 460hp ratings.
The engine combines a unit injector with a common rail system that builds torque at low revs and has flat torque curves in the 390 and 420 variants.
The torque curve in the 460hp rating is a little more peaky, with an impressive 2200Nm at 1200rpm, dropping to 1800Nm at the horsepower peak at 1800rpm.
With the 420hp version, however, the torque hits close to 1900Nm at under 1000rpm and holds in a plateau through to 1600rpm.
This engine exceeds, according to the manufacturer, Euro 6 emission standards.
The Escot-V1 12-speed transmission system, not surprisingly, has performance and handling technique similar to the close rellies of I-shift and M-drive.
The shift lever is console mounted and a straight R-N-D pull through with an M option for manual overdrive.
The transmissions have two options, one an overdrive ratio in 12th, the other a direct top slot.
The 60 tonne GVM rated flagship will find work in short to medium haul B-double applications.
"Return to base B-double work, running Brisbane to Bundaberg or Sydney to Newcastle, that type of run where the truck returns to base each night,” Mr Strambli said.
"It also fits into the local distribution, metropolitan B-double work and has application in the PBS space with different combinations.”
He said the 420hp rating is well-established in single trailer operations and the new CD 6x2s deliver flexible distribution work in applications requiring 14 pallet curtain siders or refrigerated bodies.
Mr Strambli does not consider the Quon 460hp units will infringe on sales of other VGA product.
He said a main difference is that Volvo trucks are built in Australia and have the option of a high degree of customisation while speccing choice is more limited in the Japanese truck that is fully imported after being built in Japan.
The Quon cab is suited more to day work while Volvo and Mack offer a full sleeper cab.
He an analogy: "If you buy a suit that is tailor-made you pay $2000. Off-the-shelf you pay $800. That is probably is an exaggeration in price differential, but basically you have the choice of tailor-made or a standard specification.”
The new Australian Quon line-up is now being built in Japan, order books are looking healthy we're told, and first deliveries off ships will be in 2018. (www.chinatrucks.com)
Source : bigrigs
Views : 7852
Tags : UD Trucks New Quon Australia
